Kopf_01.jpg Kopf_02.jpg Kopf_03.jpg Kopf_04.jpg Kopf_06.jpg Kopf_07.jpg Kopf_08.jpg Kopf_09.jpg Kopf_10.jpg Kopf_11.jpg Kopf_12.jpg Kopf_13.jpg Kopf_14.jpg Kopf_15.jpg Kopf_16.jpg Kopf_17.jpg Kopf_18.jpg Kopf_19.jpg Kopf_20.jpg
AbstandQuality for your hobby! Search Abstand FAQ Abstand Contact Abstand Imprint Abstand Home Abstand

Abstand

Abstand

Craft ideas and instructions

Paracord bracelet

Idea and realisation: Kathleen Hauck

enlarged picture
enlarged picture

enlarged picture
enlarged picture

List of materials

Art. no.Name of article
1802907Craft scissors, round, 13 cm, assorted colours
1012000Weave rail, for Paracord, 60 x 300 x 1,5 mm
1011999Clamp, for weave rail, 40 mm span
1012011Paracord starter kit, assorted, 2 mm x 2 m, 5 parts, blue light green white
Additional: Lighter

Instructions

1.Cut the paracord cords to the desired length and attach them to the click buckle with an attachment knot. In our example, we cut the 2 cords to a length of approx. 1 m, we made the cords approx. 21 cm long from the hanging knot and the knotted piece between the click buckle ends was then approx. 15 cm long. These measurements may vary depending on how tightly or loosely you knot them.
2.In the weaver's knot, the two outer cords form an even strand around the two standing guide cords (center). Pass the right loose end in an arc under the two guide cords to the left so that a loop is formed on the right and place it over the left loose end. Lay the left loose end to the right over the two guide cords and guide it through the loop that has just been created. Tighten both loose ends (right and left) evenly. Lay the right loose end in an arc over the two guide cords. This creates another loop on the right-hand side and pass it under the left-hand loose end. Pass the left loose end under the two guide cords and pull it through the loop. Tighten evenly to form a knot. Repeat the steps until the desired length is reached.
3.When the bracelet has reached the desired length, thread all 4 cords through the second half of the click buckle. If necessary, shorten the cord ends on the back of the bracelet slightly, heat briefly with the lighter and press against them with the lighter body. CAUTION when heating the cords, they become very hot! Take care when welding to avoid burning yourself.
Abstand
enlarged picture
enlarged picture
enlarged picture
enlarged picture
enlarged picture
enlarged picture

Abstand

Abstand

Abstand


Creative tips

more on the subject
more on the subject »

Abstand

more on the subject
more on the subject »

Abstand

more on the subject
more on the subject »

Abstand

Abstand

AbstandHave fun doing handicrafts!Abstandback to HomeAbstandto top of page